Welding Critical Structures Above Water: PATON Equipment Used in the Metro Bridge Reconstruction
The reconstruction of the Metro Bridge is a project where every weld directly affects safety. When part of the structures is welded directly above the water, on pontoons, the requirements for welding equipment and electrodes become even higher. Under these conditions, PATON welding machines and UONI-13/55 electrodes are used at the site in Kyiv. The contractor selected them for critical structures and verified them through its own incoming inspections before the work began.
The contractor has been working with PATON products for several years, and the reconstruction of the Metro Bridge has become the project with the largest volumes of PATON equipment and consumables used throughout the entire period of cooperation.
What Is Welded During the Reconstruction of the Metro Bridge
At this site, PATON is not involved in the fabrication of the bridge spans themselves. The equipment and electrodes are used for supporting structures installed beneath the spans as temporary safety elements during the reconstruction work.
These assemblies are classified as critical load-bearing structures, so the strength of the welded joint is particularly important. For this purpose, the contractor selected UONI-13/55 electrodes, which are used where higher requirements are placed on weld quality and reliability.
The electrodes were initially taken for testing, and only after successful verification did they become part of the regular working process. They were then purchased on a recurring basis for welding the supporting structures within the project.
Working on Pontoons and Welding Directly Above the Water
The most challenging aspect here is not what is being welded, but where the work is carried out. Some of the structures are assembled on pontoons, finished elements are transported under the bridge span by ferries, and final welding is performed directly above the water, on an unstable platform and in confined spaces, while the weld still has to meet the requirements for critical structures. Part of the work is also carried out using generator power, which means the welding machines operate under unstable power supply conditions.
Manual metal arc welding (MMA) is used at the site to assemble and secure the metal elements of the supporting structures in different areas of the project.
The contractor uses the PATON PRO-350 with a 380 V power supply and the PRO-250 with a 220 V power supply. Both models are designed for MMA welding. This allows the team to work with two different power supply options depending on the work area and the stage of installation.
Supply Volumes and Long-Term Cooperation
This is not the contractor’s first project using PATON products. Cooperation across the group of companies has continued for approximately 3–4 years, while the Metro Bridge reconstruction has become the first project of this scale.
The supply volumes demonstrate the actual level of product use:
- around 1 tonne of UONI-13/55 electrodes per month for approximately six months;
- approximately 15 PATON PRO-350 welding machines purchased over a period of about one to one and a half years;
- around 5 PATON PRO-250 welding machines purchased over the same period.
This is not a one-time purchase for a single stage of the project. The regular use of electrodes and around twenty welding machines confirms the systematic use of PATON products in ongoing work.
The duration of the cooperation is also important. The contractor had already been working with PATON before this project, so the transition to larger volumes was not an experiment, but a continuation of a proven choice.
Where PATON Is Used on This Project
Part of the planned work at the site has already been completed. According to preliminary information, two bridge spans have already been installed.
For critical structures, the equipment is first tested, and its suitability is then proven by the actual scope of work, year after year, on a real infrastructure project.
Do you work with critical metal structures or carry out welding in challenging conditions? A PATON welding specialist will help you select suitable equipment and electrodes for your specific project, and if necessary, we can arrange preliminary product testing before purchase.
